top of page
Search

IDS-672-10K 10,000 lb Pancake Load Cell Guide: Bare Sensor Setup, Calibration & Uses

Phone: (832) 290-3120

Email: mnmscales@yahoo.com

Contact MNM Scales for current stock, the sensor certificate, and help matching the IDS-672-10K to your indicator, amplifier or force-measurement system.

IDS-672-10K 10,000 lb Pancake Load Cell Guide

The IDS-672-10K 10,000 lb pancake load cell is a low-profile tension/compression sensor sold by MNM Scales for high-force measurement where a compact disk-style sensor is easier to package than a tall S-beam. MNM’s current listing identifies the brand as SDS, model IDS-672-10K, capacity 10,000 lb, low-profile disk/pancake construction, and states that the load cell is supplied with a certificate.

IDS-672 pancake-style load cell image used on the 10,000 lb MNM product listing

Verified product details

  • Brand shown on MNM listing: SDS.

  • Model/SKU: IDS-672-10K / IDS-672-10k.

  • Rated capacity: 10,000 lb.

  • Form: low-profile disk / pancake tension-compression load cell.

  • MNM listing states a load-cell certificate is included.

What MNM does not publish on the product page

The public listing does not state exact sensitivity, bridge resistance, excitation, dimensions, center-thread details, cable length or wiring colors. Those values matter for OEM replacement and indicator compatibility, so obtain them from the physical certificate/label or MNM before treating another pancake sensor as interchangeable.

Why use a pancake load cell?

Pancake/load-disk sensors are used where vertical space is limited and the force can be applied through a rigid, centered fixture. They are common in presses, bearing/preload fixtures, actuator test stands, structural reaction-force setups and machinery force measurement. The low-profile body does not eliminate alignment requirements: off-center force, bending and uneven contact can still produce error or damage.

Mounting and integration checklist

  1. Confirm the 10,000 lb capacity provides adequate headroom for peak, shock and preload forces.

  2. Verify the exact loading interface, dimensions, bolt pattern/threading and allowed force direction from the sensor documentation.

  3. Use flat, rigid, aligned fixtures that transfer force through the intended sensing axis.

  4. Match the sensor’s mV/V, bridge resistance, excitation and wiring to the indicator or amplifier.

  5. Calibrate after final installation with the cable and electronics that will be used in service.

Calibration and maintenance

Set zero with the final fixture installed, apply a known reference force for span, verify intermediate points, unload and check return to zero. Recalibrate after changing the load cell, indicator, amplifier, cable length, connector, or significant mechanical fixture. Keep the cable protected and inspect loading surfaces for debris, dents or uneven contact that can change the force path.

FAQ

Is the IDS-672-10K an indicator-ready scale by itself? No. This listing is the bare load-cell sensor; it needs compatible instrumentation and a mechanical fixture.

Can it measure tension and compression? The MNM title describes the product as tension/compression. The fixture and loading interface must be configured appropriately for the direction being measured.

Does a certificate mean my whole test system is calibrated? No. The complete installed system still needs calibration/verification with its electronics and fixture.

Can I replace another 10,000 lb pancake cell solely by capacity? No. Verify mechanical and electrical compatibility first.

Where to buy

 
 
 

Comments

bottom of page